Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL SYSTEM (DIAGNOSTICS)SUBARU SELECT MONITOROPERATIONHOW TO USE SUBARU SELECT MONITOR
2014 Subaru Legacy 2.5i, Automatic CVT Trans
How To Use SUBARU Select Monitor
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION How To Use SUBARU Select Monitor
NOTE:
- For detailed operation procedures, refer to "Subaru Select Monitor" operating information.
- If VDC and Subaru Select Monitor cannot communicate, check the communication circuit. < Refer to COMMUNICATION FOR INITIALIZING IMPOSSIBLE , INSPECTION, Subaru Select Monitor. >
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.