Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - SECURITY AND LOCKSSECURITY SYSTEMINSPECTIONSECURITY SYSTEM ON/OFF SETTING
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Security System On/Off Setting
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Security System On/Off Setting
- Close all doors and rear gate, and sit in the driver's seat. Press the UNLOCK button of the access key.
- Press the push button ignition switch to turn ignition ON.
- Press the central door unlock switch and open the driver's door simultaneously. (Keep the central door unlock switch pressed down.)
- When the condition in step 3) continues for 10 seconds, the system switches to a mode reverse to the current mode.
Setting Horn activation Meter display ON → OFF 2 times [AL_OF] OFF → ON Once [AL_ON]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.