Other Adjustment Operations Before Delivering The Vehicle To Customer

2014 Subaru Impreza Sport LimitedSECTION Other Adjustment Operations Before Delivering The Vehicle To Customer

Due to service and parts replacement convenience, perform the following operations before delivering the vehicle to the customer.

No. Item Check operation Adjustment operation Additional adjustment operations when replacing parts
1 Positions of devices
  • Steering
  • Room mirror
  • Door mirror
  • Seat
  • Air conditioner vent grille
Is the device set to the same position when the vehicle was received from the customer? Adjust the device to the similar position when the vehicle was received from the customer. When removing/installing each device
  • Meter, instrument panel, steering column, etc.
  • Room mirror, roof trim, sunroof assembly, etc.
  • Door mirror, door panel, etc.
  • Seat, floor carpet, parking brake lever, etc.
  • Vent grille, instrument panel, console box, etc.
2 Positions of switches
  • SI-Drive
  • Wiper, light (AUTO or OFF)
  • Headlight beam leveler
  • Illumination control
  • Room light
  • Seat heater, etc.
Is the switch set to the same position when the vehicle was received from the customer? Set the switch to the same position when the vehicle was received from the customer. When removing/installing each switch
3 Position of antenna Is the antenna set to the same position when the vehicle was received from the customer? Adjust the position of antenna. When removing/installing the antenna and washing the vehicle
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.