SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014IMPREZA SPORT LIMITEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (LAN SYSTEM (DIAGNOSTICS) (HYBRID))DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)DTC U0327: SOFTWARE INCOMPATIBILITY WITH VEHICLE SECURITY CONTROL MODULETROUBLE SYMPTOM
2014 Subaru Impreza Sport Limited

DTC U0327: Software Incompatibility With Vehicle Security Control Module: Trouble Symptom

2014 Subaru Impreza Sport LimitedSECTION Trouble Symptom
WARNING: This page is about a different car, the 2014 Subaru XV Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.

Cooperation control of keyless access does not operate properly.

DTC PROCEDURE

Step Check Yes No
1 CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.  Was the basic diagnostic procedure performed up to STEP 3? Go to step 2  . Perform the basic diagnostic procedure. < Ref. to BASIC DIAGNOSTIC PROCEDURE .>
2 CHECK DTC. 
Check the displayed DTC.		 Is U0327 a current malfunction? Go to step 3  . Go to step 6  .
3 CHECK DTC. 
Using the Subaru Select Monitor, read DTC of all the systems.		 Is the smart data no-receive detected in several modules? Replace the keyless access Control Module. < Ref. to KEYLESS ACCESS Control Module .> Go to step 4  .
4 REPLACE MODULE. 
  1. Replace the keyless access Control Module.
    NOTE: Do not perform keyless access Control Module registration.
  2. Read the DTC using Subaru Select Monitor.
 Is U0327 a current malfunction? Go to step 5  . System is normal.
NOTE: Be sure to perform keyless access Control Module registration.
5 CHECK MODULE. 
  1. Reinstall the keyless access Control Module.
  2. Replace the module that the DTC has been detected.
  3. Read the DTC using Subaru Select Monitor.
 Is U0327 a current malfunction? Replace the keyless access Control Module. < Ref. to KEYLESS ACCESS Control Module .> System is normal.
6 CHECK HARNESS. 
  1. Shake the harness, and check for poor contact.
  2. Read the DTC using Subaru Select Monitor.
 Is U0327 a current malfunction? Repair the poor contact of harness, or replace the harness. Go to step 7  .
7 CHECK CONNECTOR. 
Check the connector used for high speed CAN for poor contact.		 Is there poor contact of connector? Repair the connector that has poor contact, or replace harness. It is possible that temporary poor communication occurs. Delete the DTC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.