Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014IMPREZA SPORT LIMITEDREPAIR AND DIAGNOSISENGINE MECHANICALCOOLING SYSTEM (MECHANICAL)ENGINE COOLING SYSTEMWATER PIPE ASSEMBLYREMOVALWATER PIPE ASSEMBLY RH

2014 Subaru Impreza Sport Limited

Water Pipe Assembly RH

2014 Subaru Impreza Sport LimitedSECTION Water Pipe Assembly RH

NOTE: Water pipe assembly RH is installed to CVT model.

Disconnect the ground cable from battery. < Ref. to BATTERY , NOTE, Note.>
NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V engine restart battery sensor.
Drain engine coolant. < Ref. to DRAINING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.>
Remove the front exhaust pipe. < Ref. to REMOVAL , Front Exhaust Pipe.>
Disconnect the water hose (A) from the water pipe assembly RH, and remove the bolt (B) securing the water pipe assembly RH to the cam carrier RH.

Fig 1: Identifying Water Hose And Mounting Bolt
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolt (A) which secures the water pipe assembly RH to the cylinder head RH.
Disconnect the water pipe hose RH (B) from oil pan upper, and remove the water pipe assembly RH.

Fig 2: Identifying Water Pipe Hose And Mounting Bolt (RH)
Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.