Water Pipe Assembly RH

2014 Subaru Impreza Sport LimitedSECTION Water Pipe Assembly RH
  1. Set the water pipe assembly RH on the engine, and connect the water pipe hose RH (B) to the oil pan upper.
  2. Secure the water pipe assembly RH to the cylinder head RH with bolt (A).

    Tightening torque:Β 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)Β 

    Fig 1: Identifying Water Pipe Hose And Mounting Bolt (RH)
    G09476399Courtesy of SUBARU OF AMERICA, INC.
  3. Install the bolt (B) which secures the water pipe assembly RH to the cam carrier RH.

    Tightening torque:Β 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)Β 

  4. Connect the water hose (A) to the water pipe assembly RH.
    Fig 2: Identifying Water Hose And Mounting Bolt
    G09476398Courtesy of SUBARU OF AMERICA, INC.
  5. Install the front exhaust pipe. < Ref. to INSTALLATION , Front Exhaust Pipe.>
  6. Connect the battery ground terminal. < Ref. to BATTERY , NOTE, Note.>
  7. Fill engine coolant. < Ref. to FILLING OF ENGINE COOLANTΒ , REPLACEMENT, Engine Coolant.>
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.