Check Security System Condition Memory

2014 Subaru Impreza Sport LimitedSECTION Check Security System Condition Memory
  1. Pull out the key from the ignition switch, or turn the ignition to OFF.
  2. Close all the doors, trunk lid or rear gate.
  3. Open the front hood.
  4. Press the LOCK button of the keyless transmitter or access key.
    NOTE: Wait until the security indicator light blinks twice within 0.5 seconds at 2 second intervals. If the 30 second monitoring lag has been set, wait for 30 seconds.
  5. Disconnect the ground cable from battery. < Ref. to BATTERY , NOTE, Note.>
    NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V engine restart battery sensor.
  6. Connect the ground cable to battery. < Ref. to BATTERY , NOTE, Note.>
  7. Check that the security indicator light blinks twice within 0.5 seconds at 2 second intervals. When it does not blink, replace the body integrated unit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.