Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014IMPREZA SPORT LIMITEDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSREMOTE OPENERSREMOVALTRUNK LID OPENER

2014 Subaru Impreza Sport Limited

Trunk Lid Opener

2014 Subaru Impreza Sport LimitedSECTION Trunk Lid Opener

Remove the cover - handle.
1. Open the cover by using a flat tip screwdriver.
2. Remove the screws and detach the cover - handle.
  
  Fig 1: Removing Cover - Handle
  Courtesy of SUBARU OF AMERICA, INC.
Remove the pull handle - opener.
1. Remove the nut.
2. Remove the cable from pull handle - opener.
  
  Fig 2: Removing Cable From Pull Handle - Opener
  Courtesy of SUBARU OF AMERICA, INC.
Remove the trim panel - trunk side RH. < Ref. to TRUNK ROOM TRIM , REMOVAL, Trunk Room Trim.>
Remove the lower inner trim. < Ref. to REMOVAL , Lower Inner Trim.>
Remove the trim panel - trunk lid. < Ref. to TRUNK LID TRIM , REMOVAL, Trunk Room Trim.>
Disconnect the cable from the lock assembly - trunk lid.

Fig 3: Disconnecting Cable From Lock Assembly - Trunk Lid
Courtesy of SUBARU OF AMERICA, INC.
Remove the cable clip, and remove the cable.

Fig 4: Identifying Cable Clip
Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.