Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014IMPREZA SPORT LIMITEDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSPUSH BUTTON IGNITION SWITCHINSPECTION
2014 Subaru Impreza Sport Limited
Push Button Ignition Switch: Inspection
2014 Subaru Impreza Sport LimitedSECTION Inspection
On the vehicle inspection
Preparation tool:
Circuit tester
- Check the continuity between push button ignition switch terminals.
Terminal No. Inspection conditions Specification Connection diagram 4 (COM) - 5 (GND) Always Continuity exists 7 (SSW1) - 5 (GND) Push button ignition switch released → pressed Continuity exists 2 (SSW2) - 5 (GND) Push button ignition switch released → pressed Continuity exists - Check the push button ignition switch operation when battery voltage is applied between the terminals of the push button ignition switch.
Terminal No. Inspection conditions Specification Connection diagram 11 (SWIL) - 5 (GND) Connect battery to the terminals Goes off → Red switch illumination light 12 (INDS) - 5 (GND) Turns off → Switch indicator lights in green 13 (INDW) - 5 (GND) Turns off → Switch indicator lights in orange - Replace the push button ignition switch if the inspection result is not within the standard value.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.