SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014IMPREZA SPORT LIMITEDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSKEYLESS ENTRY SYSTEMINSPECTIONCHECK ROOM LIGHT OPERATION
2014 Subaru Impreza Sport Limited

Check Room Light Operation

2014 Subaru Impreza Sport LimitedSECTION Check Room Light Operation
Step Check Yes No
1 CHECK ROOM LIGHT OPERATION. 
Make sure the room light illuminates when the room light switch is ON, and goes off when the switch is OFF.		 Does the room light illuminate or go off? Go to step 2  . Check the room light circuit. < Ref. to INSPECTION , Room Light.>
2 CHECK ROOM LIGHT OPERATION. 
  1. Turn the room light switch to the "DOOR" position.
  2. Open and close any door.
 Does the room light illuminate ←→ go off (including off delay) when the door is opened and closed? Go to step 3  . Go to step 4  .
3 CHECK KEYLESS ENTRY OPERATION. 
Press the LOCK/UNLOCK button of the keyless transmitter.		 Does it operate properly? Room light is normal. Check keyless entry system. < Ref. to SYMPTOM CHART , INSPECTION, Keyless Entry System.>
4 CHECK ROOM LIGHT. 
Check the room light. < Ref. to INSPECTION , Room Light.>		 Is room light normal? Go to step 5  . Replace the bulb or room light assembly.
5 CHECK HARNESS. 
  1. Disconnect the connectors of body integrated unit and room light.
  2. Check the harness between body integrated unit and room light.

    Connector & terminal (i84) No. 4 - (R52) No. 2: 

 Is harness normal? Go to step 6  . Repair or replace the harness.
6 CHECK HARNESS. 
Measure the voltage between the room light connector and chassis ground.
Connector & terminal (R52) No. 3 (+) - Chassis ground (-): 		 Is the voltage 10 V or more? Replace the body integrated unit. < Ref. to BODY INTEGRATED UNIT .> Repair or replace the harness.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.