SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSSUBARU2014IMPREZA SPORT LIMITEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)SYSTEM OPERATION CHECK MODEOPERATION
2014 Subaru Impreza Sport Limited

System Operation Check Mode: Operation

2014 Subaru Impreza Sport LimitedSECTION Operation
  1. On «Main Menu» display, select {Each System Check}.
  2. On «System Selection Menu» display, select {Keyless access system}.
  3. On «Keyless access system» display, select {Work Support}.
  4. Select {System Operation Check Mode}.
  5. Select the check point and click [OK].
  6. Select [Exit] to exit the drive item mode. The screen will return to the «Drive item» screen.
NOTE: Each output check continues to run for five seconds before stopping automatically.
Data Keyless access CM output check Remarks
Tuner power supply ON (indoor tuner) Output Perform the power supply check for the receiver.
Stop
Driver's external transmitter Output Perform the output check for the driver's side door outside antenna.
Stop
Passenger's external transmitter Output Perform the output check for the passenger's side door outside antenna.
Stop
STSW Output Turn on the STSW. (2)
Stop
IGN2 Output Turn on the IGN2.
Stop
IGN1 Output Turn on the IGN1.
Stop
ACC Output Turn on the ACC.
Stop
Start SW character illumination lighted Output Perform ON output of the push button ignition switch back-up light. (1)
Stop
Start SW indicator lighted (green) Output Perform ON output of the push button ignition switch back-up light. (1)
Stop
Start SW indicator lighted (orange) Output Perform ON output of the push button ignition switch back-up light. (1)
Stop
Steering lock power supply Output Output power supply signal from power supply CM to steering lock CM.
Stop
(1) When lit by a condition other than for a system operation check mode, it will not become unlit even when set to OFF or no output.
(2) When performed with ignition switch ON, engine will start. Therefore, great care must be exercised.
NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.