Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 9 (ENGINE CONTROL SYSTEM (DIAGNOSTICS) (H4DOTC))DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)DTC P0500: VEHICLE SPEED SENSOR "A"DTC DETECTING CONDITION
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans
DTC P0500: Vehicle Speed Sensor "A": DTC Detecting Condition
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
- Immediately at fault recognition
- GENERAL DESCRIPTION < Ref. to DTC P0500: VEHICLE SPEED SENSOR "A" , Diagnostic Trouble Code (DTC) Detecting Criteria. >
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode < Ref. to
OPERATION , Clear Memory Mode. >, and Inspection Mode < Ref. to
PROCEDURE , Inspection Mode. >.
DTC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC OF VDC. Check DTC of VDC. |
Is DTC of VDC displayed? | Perform the diagnosis according to DTC. < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > | Repair the poor contact of ECM connector. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.