Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (AUTOMATIC TRANSMISSION CVT (TR690) - SERVICE INFORMATION)AWD ON/OFF SWITCHING MODEPROCEDURE
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans
AWD ON/OFF Switching Mode: Procedure
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.
- On completing the work in FWD, switch back in AWD.
- Shift the select lever to "P" range.
- Connect the Subaru Select Monitor to data link connector.
- Turn the ignition switch to ON. (For model with push button start, press the push button ignition switch twice without depressing brake pedal.)
- Turn off all switches causing an electrical load, such as headlights, A/C, seat heater and rear defogger.
- Select {Work Support} in the «Transmission Diagnosis» display screen of the Subaru Select Monitor.
- Select {Maintenance mode} in the «Work Support» screen of Subaru Select Monitor.
- Select {AWD ON/OFF switching mode} in the «Maintenance mode» screen of the Subaru Select Monitor.
- Follow the messages displayed on the Subaru Select Monitor screen when working.
Switching completes successfully if any of the following messages is displayed.
- When switching from AWD to FWD: {Switched to FF. To return to AWD, perform basic mode again.}
- When switching from FWD to AWD: {Switched to AWD. To return to FF, perform basic mode again.}
NOTE:- If communication error occurs during switching mode, start in the "AWD ON/OFF switching mode" again.
- If operation is interrupted before the successful end message is displayed, perform the {AWD ON/OFF switching mode} from the beginning until confirming the operation is successfully ended. If this mode fails to complete successfully, the cause is as follows.
- Select lever is not in "P" range.
- Engine is running.
- For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.