SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE COOLING SYSTEM (H4DOTC))WATER PIPE ASSEMBLYINSTALLATIONWATER PIPE ASSEMBLY RH
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans

Water Pipe Assembly RH

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Water Pipe Assembly RH
WARNING: This page is about a different variant/trim than selected.
  1. Set the water pipe assembly RH on the engine, and connect the water pipe hose RH (B) to the oil pan upper.
  2. Install the bolt (A) which secures the water pipe assembly RH to the cylinder head RH.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 1: Identifying Water Pipe Hose RH Mounting Bolt
    G09480755Courtesy of SUBARU OF AMERICA, INC.
  3. Connect the water hose (A) to the water pipe assembly RH, and install the bolt (B) which secures the water pipe assembly RH to the cam carrier RH.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 2: Identifying Water Hose To Water Pipe Assembly RH Bolts
    G09476398Courtesy of SUBARU OF AMERICA, INC.
  4. Install the front exhaust pipe. < Ref. to INSTALLATION , Front Exhaust Pipe. >
  5. Install the oil pipe assembly. < Ref. to OIL PIPE ASSEMBLY , INSTALLATION, Oil Pipe. >
  6. Connect the battery ground terminal.
  7. Fill engine coolant. < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.