Section 4 (Intake Induction (H4DOTC)): Turbocharger: Disassembly

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Disassembly
WARNING: This page is about a different variant/trim than selected.
  1. Remove the union screw pipe assembly from the turbocharger.
    Fig 1: Locating Turbocharger Union Screw
    G09480112Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the turbocharger pipe from the turbocharger.
    Fig 2: Locating Turbocharger Pipe Bolt
    G09480113Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the air control hose from the turbocharger.
    Fig 3: Locating Turbocharger Air Control Hose Clamp
    G09480114Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the stud bolt from the turbocharger.
    Fig 4: Locating Turbocharger Stud Bolts
    G09480115Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the exhaust stay from the turbocharger.
    Fig 5: Locating Turbocharger Exhaust Stay Bolts
    G09480116Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.