Intake Duct No. 3

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Intake Duct No. 3
WARNING: This page is about a different variant/trim than selected.
  1. Align the triangle mark (A) on the intake duct No. 3 to the rib (B) on the throttle body, and install the intake duct No. 3 to the throttle body.
    NOTE:
    • Use a new insulator.
    • Apply a thin coat of SUBARU PS fluid (K0515YA000) or liquid paraffin to the inner periphery of the insulator.
    • When inserting the intake duct No. 3 to the throttle body, be careful that the insulator is not turned over.

    Tightening torque:Β 

    3 N.m (0.3 kgf-m, 2.2 ft-lb)Β 

    Fig 1: Locating Intake Duct No. 3 Throttle Body Bolt
    G09480094Courtesy of SUBARU OF AMERICA, INC.
  2. Install the clip which secures the brake booster vacuum hose to the intake manifold.
    Fig 2: Locating Brake Booster Vacuum Hose Clips
    G09479960Courtesy of SUBARU OF AMERICA, INC.
  3. Install the intercooler. < Ref. to INSTALLATIONΒ , Intercooler. >
  4. Connect the battery ground terminal.
  5. Install the collector cover.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.