SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (FUEL INJECTION FUEL SYSTEMS (H4DOTC))ENGINE WIRING HARNESSINSTALLATION
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans

Engine Wiring Harness: Installation

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Installation
WARNING: This page is about a different variant/trim than selected.
  1. Set the engine wiring harness to the engine, and connect the connector.
    • Structural diagram 1
      Fig 1: Engine Wiring Harness Structural Diagram (1 Of 2)
      G09479718Courtesy of SUBARU OF AMERICA, INC.
    • Structural diagram 2
      Fig 2: Engine Wiring Harness Structural Diagram (2 Of 2)
      G09479719Courtesy of SUBARU OF AMERICA, INC.
  2. Install the engine wiring harness.

    Tightening torque: 

    19 N.m (1.9 kgf-m, 14.0 ft-lb) 

  3. Install the intake manifold. < Ref. to INSTALLATION , Intake Manifold. >
  4. Connect the battery ground terminal.
    Fig 3: Locating Engine Wiring Harness Mounting Bolts
    G09479717Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.