SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (FUEL INJECTION FUEL SYSTEMS (H4DOTC))CRANKSHAFT POSITION SENSORREMOVAL
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans

Crankshaft Position Sensor: Removal

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Removal
WARNING: This page is about a different variant/trim than selected.
  1. Remove the clip (A), lift the front of the collector cover in the direction of arrow, and then remove the collector cover.
    Fig 1: Removing Front Collector Cover
    G09479721Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Remove the intercooler. < Ref. to REMOVAL , Intercooler. >
  4. Remove the throttle body. < Ref. to REMOVAL , Throttle Body. >
  5. Remove the bolts securing the engine harness.
    Fig 2: Locating Engine Harness Bolts
    G09479729Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the connector (A) from the crankshaft position sensor, and remove the crankshaft position sensor from the cylinder block.
    Fig 3: Locating Crankshaft Position Sensor Connector
    G09479730Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.