Starting System / Charging System (H4DO): Starter: Disassembly

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Disassembly
  1. Disconnect the terminal M from the magnet switch assembly.
    Fig 1: Locating Nut Of Magnet Switch Assembly
    G07665119Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the magnet switch assembly from the starter housing assembly.
    Fig 2: Locating Bolts Of Magnet Switch Assembly
    G09476690Courtesy of SUBARU OF AMERICA, INC.
  3. Remove screws (A) of the brush holder assembly, and through bolts (B) on both sides, and remove the starter cover assembly.
    Fig 3: Identifying Screws And Bolts Of Starter Cover Assembly
    G07665121Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the brush holder assembly from the armature assembly.
    NOTE: Hold the brush with your fingers so that the brush spring does not come flying out.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.