SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE MECHANICAL (H4DO)CHAIN COVERASSEMBLY
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans

Chain Cover: Assembly

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Assembly
  1. Install the sensor cover to the chain cover.
    NOTE:
    • Use new O-rings.
    • Apply a coat of engine oil to the O-rings.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 1: Locating Sensor Cover Bolts
    G09475999Courtesy of SUBARU OF AMERICA, INC.
  2. Install the actuator cover to chain cover.
    NOTE:
    • Use new O-rings.
    • Apply a coat of engine oil to the O-rings.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 2: Locating Actuator Cover Bolts
    G09475998Courtesy of SUBARU OF AMERICA, INC.
  3. Install the camshaft position sensor. < Ref. to INSTALLATION , Camshaft Position Sensor. >
  4. Install the oil control solenoid. < Ref. to INSTALLATION , Oil Control Solenoid. >
  5. Install the engine oil temperature sensor. < Ref. to INSTALLATION , Engine Oil Temperature Sensor. >
  6. Install the oil pressure switch. < Ref. to INSTALLATION , Oil Pressure Switch. >
  7. Install the engine oil filter and the oil pump union. < Ref. to INSTALLATION , Engine Oil Filter. >
  8. Install the oil filler cap.
    Fig 3: Locating Oil Filler Cap
    G08316938Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.