Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSKEY LOCK CYLINDERSREPLACEMENTGLOVE BOX LID

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans

Glove Box Lid

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Glove Box Lid

Remove the pocket assembly.
1. Attach the protective tape (a) to the panel center LWR.
2. Remove the damper COMPL - pocket.
3. Release the stoppers and remove the pocket assembly by pulling it toward you.
  
  Fig 1: Locating Glove Box Lid
  Courtesy of SUBARU OF AMERICA, INC.
Replace the key cylinder.
1. Pull up the lock knob.
2. Push out the key cylinder from the pocket assembly while pressing in the metal plate.
  
  Fig 2: Pushing Out Key Cylinder From Pocket Assembly
  Courtesy of SUBARU OF AMERICA, INC.
Install each part in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.