Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electrical Specification
- Body integrated unit
For I/O signals of the body integrated unit, refer to BODY CONTROL SYSTEM (DIAGNOSTICS). < Ref. to CONTROL MODULE I/O SIGNAL . >
- Engine Control Module
For I/O signals of ECM, refer to ENGINE (DIAGNOSTICS). < Ref. to ELECTRICAL SPECIFICATION , Engine Control Module (ECM) I/O Signal. >
- Transmission Control Module
For I/O signals of TCM, refer to AUTOMATIC TRANSMISSION (DIAGNOSTICS). < Ref. to TRANSMISSION CONTROL MODULE (TCM) I/O SIGNAL . >
- VDC Control Module, steering angle sensor, yaw rate & G sensor
For the module I/O signals of VDC Control Module, steering angle sensor, and yaw rate & G sensor, refer to VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS). < Ref. to CONTROL MODULE I/O SIGNAL . >
- Power Steering Control Module
For unit I/O signals of Power Steering Control Module, refer to POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS). < Ref. to CONTROL MODULE I/O SIGNAL . >
- A/C control panel
For unit I/O signals of A/C control panel, refer to HVAC SYSTEM (DIAGNOSTICS). < Ref. to AUTO A/C CONTROL MODULE I/O SIGNAL . >
- Combination meter
For I/O signals of combination meter, refer to INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS). < Ref. to CONTROL MODULE I/O SIGNAL . >
- Airbag Control Module
For I/O signals of the Airbag Control Module, refer to AIRBAG SYSTEM (DIAGNOSTICS). < Ref. to AIRBAG CONTROL MODULE I/O SIGNAL . >
- High grade MFD
For I/O signals of high grade MFD, refer to INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS). < Ref. to CONTROL MODULE I/O SIGNAL . >
- Keyless Access Control Module
For I/O signals of Keyless Access Control Module, refer to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS). < Ref. to CONTROL MODULE I/O SIGNAL . >
- Stereo camera
For I/O signals of stereo camera, refer to EyeSight (Diagnostics). < Ref. to STEREO CAMERA , ELECTRICAL SPECIFICATION, Control Module I/O Signal. >
- Auto Headlight Beam Leveler Control Module
For I/O signals of Auto Headlight Beam Leveler Control Module, refer to AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS). < Ref. to AUTO HEADLIGHT BEAM LEVELER CONTROL MODULE , ELECTRICAL SPECIFICATION, Control Module I/O Signal. >
- Data link connector
For I/O signals of data link connector, refer to ENGINE (DIAGNOSTICS). < Ref. to DATA LINK CONNECTOR . >
* CAN sleep state:
Hold on for approx. one minute with ignition OFF and the doors, trunk, rear gate all closed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.