Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL (DIAGNOSTICS)SUBARU SELECT MONITOROPERATIONFUNCTION CHECK
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans
Function Check
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Function Check
| Display | Contents of display | Index No. |
|---|---|---|
| ABS Sequence Control Mode | Operate the valve and pump motor continuously to perform the ABS sequence control. | < Ref. to ABS SEQUENCE CONTROL . > |
| VDC Check Mode | Operate the valve and pump motor continuously to perform the VDC sequence control. | < Ref. to VDC SEQUENCE CONTROL . > |
| VSC(VDC) Centering Mode | Set the steering angle sensor neutral position, and the lateral G sensor and longitudinal G sensor "0" point. | < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U). > |
| Brake Lamp Lighting Operation Mode | Activate the brake light relay to illuminate the brake light. | < Ref. to BRAKE LAMP LIGHTING OPERATION MODE BY SUBARU SELECT MONITOR , OPERATION, Brake Lamp Relay. > |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.