Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSGLASS/WINDOW/MIRRORSPOWER WINDOW CONTROL SWITCHINSTALLATION
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans
Power Window Control Switch: Installation
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Installation
CAUTION:
- After installing the switch - power window main, always perform the initial setting.
Failure to do so may cause the improper activation of auto-reverse operation for pinching hazard prevention.
- Use protective paper to avoid damage to the trim panel.
- Install each part in the reverse order of removal.
- Perform initial setting operation (reset operation A). < Ref. to RESET OPERATION A , OPERATION, Power Window System. >
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.