SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSGLASS/WINDOW/MIRRORSPOWER WINDOW CONTROL SWITCHINSPECTIONMAIN SWITCH
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans

Main Switch

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Main Switch
  • Driver's seat
CAUTION: Since the switch - power window main is controlled by CPU, do not check continuity for switch alone with the circuit tester. Performing continuity check with circuit tester can damage the switch - power window main circuit.

Check output from the switch - power window main to the driver's side motor using the oscilloscope function in the Subaru Select Monitor.

  1. Remove the switch - power window main.
  2. Connect the battery and the Subaru Select Monitor to the switch - power window main terminal.
    CAUTION: Never mix up the terminals when connecting the harness connector of the switch - power window main and the battery. If the connection is wrong, the switch - power window main may be damaged.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.