Function Setting (Customize): Procedure

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Procedure
  1. Check that the vehicle status is as follows:
    • Ignition switch OFF
    • One window is completely open
    • Keyless access system is activated (or disabled if re-activating)
  2. Sit in the driver's seat with the door closed and press the door lock switch to UNLOCK once.
  3. Open the driver's door within five seconds.
  4. Within 5 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
  5. Within 30 seconds, perform the closing β†’ opening operation of the driver's door twice.
  6. Within 30 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
  7. Within 30 seconds, perform the closing β†’ opening operation of the driver's door once.
  8. Within five seconds, close the driver's door.
    NOTE:
    • Perform the same procedures to re-activate the keyless access system from the disabled condition.
    • If the driver's door is opened or closed in step Β 4) and step Β 6), the cancel operation is disabled.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.