Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014FORESTER 2.5I, ENG CD FB25BA, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTGAUGES & INSTRUMENT PANELSINSTRUMENTATION/DRIVER INFO (SERVICE INFORMATION)MULTI-FUNCTION DISPLAY (MFD)REMOVAL
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard Trans
Multi-function Display (MFD): Removal
2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Removal
- Disconnect the ground cable from battery.
- Remove the panel center assembly.CAUTION:
- Do not put your finger on the fin of the air vent grille. Doing so may damage the fin.
- Pull the panel center assembly slowly. Pulling with excessive force may damage the connector.
- On manual A/C models, disconnect the control cables from both sides of the heater and cooling unit assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.