2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Front Suspension: Cradle: Installation

  1. Install each part in the reverse order of removal.
    CAUTION:
    • Use a new bolt and self-locking nut. For parts which are not reusable, refer to "COMPONENT". Refer to , COMPONENTΒ , General Description.
    • Perform installation of the universal joint when the tilt position of the steering column is at the lowest position.
    • Tighten the bolts of the universal joint in the order of gearbox side and column shaft side.
    • Be sure to follow the tightening order and tightening torque of universal joint to avoid the steering effort from becoming heavy.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.