Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Symptom Chart
| Symptoms | Repair order | Reference |
|---|---|---|
| The door lock control system does not operate. | 1. Remove and visually check the following fuses.
|
If the fuse is blown out, replace the fuse with a new part. When there is no defective with the fuse, check the power supply and ground circuit. Refer to , CHECK POWER SUPPLY AND GROUND CIRCUIT , INSPECTION, Door Lock Control System. |
| 2. Check the power supply and ground circuit for body integrated unit. | Refer to , CHECK POWER SUPPLY AND GROUND CIRCUIT , INSPECTION, Door Lock Control System. | |
| 3. Check the door lock switch and the circuit. | Refer to , CHECK DOOR LOCK SWITCH , INSPECTION, Door Lock Control System. | |
| 4. Check the rear gate/trunk opener button and the circuit. | Refer to , CHECK REAR GATE/TRUNK OPENER BUTTON SWITCH CIRCUIT , INSPECTION, Door Lock Control System. | |
| 5. Check the door lock actuator and the circuit. | Refer to , CHECK DOOR LOCK ACTUATOR AND CIRCUIT. , INSPECTION, Door Lock Control System. | |
| A specific door lock actuator does not operate. | Check the door lock actuator and circuit. | Refer to , CHECK DOOR LOCK ACTUATOR AND CIRCUIT. , INSPECTION, Door Lock Control System. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.