Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Subaru Outback Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE
Transmission Case: Adjustment
NOTE:
When replacing the transmission case with a new part, perform the following check and adjustment for the selection.
- Select the thrust bearing for the forward clutch assembly. Refer to , ADJUSTMENT , Forward Clutch Assembly.
- Select the snap ring for the reduction gear. Refer to , ADJUSTMENT , Reduction Driven Gear.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.