Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Forward Clutch Assembly: Adjustment
- Measure depth "A" from the ST upper face to the washer catch surface.
ST 398643600 GAUGE
- Install the forward clutch assembly to intermediate case.
- Setting the ST, measure height "B" from the ST upper side to the immediate case mating surface.
ST 499575600 GAUGE
- Obtain the thickness of washer using the following formula.
Calculation formula:
T (mm) = (A - 15) - (B - 15) - (0.35 - 0.70)
[T (in) = (A - 0.591) - (B - 0.591) - (0.014 - 0.028)]
T: Washer thickness
A: Depth from the ST upper face to the washer catch surface
B: Height from the upper surface of the ST to the mating surface of the intermediate case
15 mm (0.591 in): Thickness of ST
0.35 - 0.70 mm (0.014 - 0.028 in): Clearance
- Select the washer matching value "T" obtained from step Β 4).
Washer Part number Washer thickness mm (in) 803034040 1.0 (0.039) 803034041 1.2 (0.047) 803034042 1.4 (0.055) 803034043 1.6 (0.063)
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
