Accelerator Pedal Position Sensor: Service and Repair

2012 Subaru Impreza WRX STI F4-2.5L DOHC TurboSECTION Service and Repair
Accelerator Pedal

REMOVAL

1. Disconnect the ground cable from battery.






2. Disconnect the connector (A).
3. Remove the nut (B) securing accelerator pedal assembly, and remove the accelerator pedal assembly.






INSTALLATION

Install in the reverse order of removal.

Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

DISASSEMBLY

NOTE: The accelerator pedal cannot be disassembled.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.