Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2008FORESTER F4-2.5L DOHC TURBOREPAIR AND DIAGNOSISBODY AND FRAMEROOF AND ASSOCIATED COMPONENTSSUNROOF / MOONROOFSERVICE AND REPAIRREMOVAL AND REPLACEMENT
2008 Subaru Forester F4-2.5L DOHC Turbo
Removal and Replacement
2008 Subaru Forester F4-2.5L DOHC TurboSECTION Removal and Replacement
SUNROOF ASSEMBLY
REMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the roof trim.
3. Remove the sunroof lid.
4. Disconnect the four drain tubes (A) from the sunroof frame.
5. Disconnect the sunroof harness connector.
6. Remove the bolts and then remove the frame bracket.
7. Remove the nuts and bolts to remove the sunroof frame.
INSTALLATION
Install in the reverse order of removal.
CAUTION: Be careful not to snag the harness.
NOTE:
- Be sure to connect the harness connector.
- When installing the drain tube, insert it securely into drain pipe.
REMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the roof trim.
3. Remove the sunroof lid.
4. Disconnect the four drain tubes (A) from the sunroof frame.
5. Disconnect the sunroof harness connector.
6. Remove the bolts and then remove the frame bracket.
7. Remove the nuts and bolts to remove the sunroof frame.
INSTALLATION
Install in the reverse order of removal.
CAUTION: Be careful not to snag the harness.
NOTE:
- Be sure to connect the harness connector.
- When installing the drain tube, insert it securely into drain pipe.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.