Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION/DRIVER INFOCOMBINATION METERREMOVAL
2007 Subaru Outback Limited, 4D Sedan, Standard
Combination Meter: Removal
2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Removal
- Disconnect the ground cable from the battery.
- Set the tilt steering at the lowest position.
- Remove the instrument panel lower cover. <Ref. to REMOVAL , Instrument Panel Lower Cover .>
- Remove the screws of the combination meter (one on the upper side, two on lower side) and pull while tilting the meter towards yourself.
- Disconnect the connector in the rear side of combination meter to remove meter.CAUTION:
- Be careful not to damage the meter or instrument panel.
- Pay particular attention to avoid damaging the meter glass.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.