SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION/DRIVER INFOCLOCK SYSTEMINSPECTIONCHECK ILLUMINATION CIRCUIT
2007 Subaru Outback Limited, 4D Sedan, Standard

Check Illumination Circuit

2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Check Illumination Circuit
DIAGNOSTIC PROCEDURE CHART

Step Check Yes No
1 CHECK ILLUMINATION CIRCUIT POWER SUPPLY. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the clock harness connector.
  3. Turn the ignition switch and lighting switch to ON.
  4. Measure the voltage between the clock harness connector and chassis ground.

    Connector & terminal 

    Normal meter: 

    (i59) No. 1 (+) - Chassis ground (-): 

 Is the voltage 10 V or more? Replace the clock body. Check the harness for a open or short between the fuse and clock.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.