Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)SUBARU SELECT MONITOROPERATIONREAD CURRENT DATA
2007 Subaru Outback Limited, 4D Sedan, Standard
Read Current Data
2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Read Current Data
- On the «Main Menu» display screen, select the {Each System Check}.
- On the «System Selection Menu» display screen, select the {Brake Control}.
- Select the [OK] after {VDC} is displayed.
- On the «Brake Control Diagnosis» display screen, select the {Current Data Display/Save}.
- On the «Display Menu» screen, select the data display method.
- Using the scroll key, scroll the display screen up or down until necessary data is shown.
- A list of the support data is shown in the following table.SUPPORT DATA REFERENCE CHART
Display Contents to be monitored Unit of measure FR Wheel Speed Wheel speed detected by front ABS wheel speed sensor RH is displayed. km/h or MPH FL Wheel Speed Wheel speed detected by front ABS wheel speed sensor LH is displayed. km/h or MPH RR Wheel Speed Wheel speed detected by rear ABS wheel speed sensor RH is displayed. km/h or MPH RL Wheel Speed Wheel speed detected by rear ABS wheel speed sensor LH is displayed. km/h or MPH Steering Angle Sensor Steering angle detected by steering angle sensor is displayed. deg Yaw Rate Sensor Vehicle angular speed detected by yaw rate sensor is displayed. deg/s Pressure Sensor Brake fluid pressure detected by pressure sensor is displayed. bar Lateral G Sensor Vehicle lateral acceleration detected by lateral G sensor is displayed. m/s (m/s/2) IG power supply voltage Voltage supplied to VDCCM&H/U is displayed. V E/G Control Prohibited Flag Engine control command signal is displayed. 1 or 0 ABS Control Flag ABS operation condition is displayed. ON or OFF EBD Control Flag EBD operation condition is displayed. ON or OFF TCS Control Flag TCS operation condition is displayed. ON or OFF VDC Control Flag VDC operation condition is displayed. ON or OFF VDC OFF Light ON/OFF condition of VDC OFF indicator light is displayed. ON or OFF EBD Warning Light ON operation of the EBD warning light is displayed. ON or OFF ABS Warning Light ON operation of the ABS warning light is displayed. ON or OFF VDC Warning Light ON operation of the VDC warning light is displayed. ON or OFF Valve Relay Signal Valve relay operation signal is displayed. ON or OFF Motor Relay Signal Motor relay operation signal is displayed. ON or OFF Motor Relay Monitor Voltage applied to the motor relay is displayed. V OFF Switch Signal Operation condition of VDC OFF switch is displayed. ON or OFF Brake Switch Brake ON/OFF is displayed. ON or OFF NOTE: For details concerning operation procedures, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.