SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)SUBARU SELECT MONITOROPERATIONPARAMETER CHECK
2007 Subaru Outback Limited, 4D Sedan, Standard

Parameter Check

2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Parameter Check
NOTE: The parameter data registered in the VDCCM is shown on the display.
  1. Connect the Subaru Select Monitor III.
  2. On the «Main Menu» display screen, select the {Each System Check}.
  3. On the «System Selection Menu» display screen, select the {Brake Control}.
  4. Select the [OK] after {VDC} is displayed.
  5. On the "Brake Control Diagnosis" display screen, select {Parameter Check}.
  6. On the {Parameter Check} display screen, check that the applied model and grade of the target vehicle are included and select the [OK].
  7. If the applied model and grade of the target vehicle are not included on the {Parameter Check} display screen, perform parameter selection and registration. <Ref. to PARAMETER SELECTION , OPERATION, Subaru Select Monitor .>
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.