Outer Mirror Assembly: Inspection

2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Inspection

Check that the rearview mirror moves properly when the battery voltage is applied to terminals.

  • Model with side turn signal light
    Fig 1: [Identifying Rear View Mirror Connector Terminal - Model With Side Turn Signal Light]
    G05022630Courtesy of SUBARU OF AMERICA, INC.
    TERMINAL REFERENCE CHART

    Switch position Terminal No.
    OFF -
    UP 6 (+) and 3 (-) or 8 (-)
    DOWN 3 (+) or 8 (+) and 6 (-)
    LEFT 7 (+) and 3 (-) or 8 (-)
    RIGHT 3 (+) or 8 (+) and 7 (-)
  • Model without side turn signal light
    Fig 2: [Identifying Rear View Mirror Connector Terminal - Model Without Side Turn Signal Light]
    G05022631Courtesy of SUBARU OF AMERICA, INC.
    RESISTANCE SPECIFICATION CHART

    Switch position Terminal No.
    OFF -
    UP 4 (+) and 2 (-) or 6 (-)
    DOWN 2 (+) or 6 (+) and 4 (-)
    LEFT 5 (+) and 6 (-) or 2 (-)
    RIGHT 6 (+) or 2 (+) and 5 (-)

    Replace the outer mirror assembly if defective.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.