Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSFRONT DOOR GLASSREMOVAL

2007 Subaru Outback Limited, 4D Sedan, Standard

Front Door Glass: Removal

2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Removal

Remove the front door trim.
< Ref. to REMOVAL , Door Trim. >
Remove the sealing cover. < Ref. to REMOVAL , Front Sealing Cover. >
Remove the outer mirror assembly. < Ref. to REMOVAL , Outer Mirror Assembly. >
Remove clip (A), and remove the front end of the weather strip.

Fig 1: Identifying Front End Of Weather Strip Clip
Courtesy of SUBARU OF AMERICA, INC.
Remove the gusset.

Fig 2: Locating Gusset Clip
Courtesy of SUBARU OF AMERICA, INC.
Remove the stabilizers.

Fig 3: Locating Stabilizers Clips
Courtesy of SUBARU OF AMERICA, INC.
Remove clips (A), and remove the rear end of the weather strip.

Fig 4: Locating Rear End Of Weather Strip Clips
Courtesy of SUBARU OF AMERICA, INC.
Remove screw (A) from the rear end of the weather strip outer, to remove the weather strip outer.

Fig 5: Removing Rear End Of Weather Strip Outer Screw
Courtesy of SUBARU OF AMERICA, INC.
Remove the screws to remove the guide assembly.
Operate the power window switch to move the glass to the position shown in the figure, then remove the two nuts through the service holes.

Fig 6: Locating Guide Assembly Screws
Courtesy of SUBARU OF AMERICA, INC.
Remove the door glass.

Fig 7: Identifying Door Glass
Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.