Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSTRANSMITTERREPLACEMENTREGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR
2007 Subaru Outback Limited, 4D Sedan, Standard
Registration Of Keyless Transmitter With SUBARU Select Monitor
2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Registration Of Keyless Transmitter With SUBARU Select Monitor
NOTE:
- A maximum of four keyless transmitter can be registered for each individual vehicle.
- When replacing or adding the keyless transmitter, new registration of transmitter is necessary.
- Connect the Subaru Select Monitor to the vehicle.
- Turn the ignition switch to ON.
- From the «Main menu» on the Subaru Select Monitor, select the {2. Check individual system} → {7. Integrated unit mode} → {8. Transmitter ID registration}, and press the [YES] key.
- Input the 8-digit ID number attached to the plastic bag of the transmitter, then press the [YES] key.NOTE: Press the x key on the Subaru Select Monitor to increase the number, and the [x] key to decrease. Press the [<] key to move to the digit in the left, and [>] to the right.
- The ID number you have entered will be shown. Make sure that the ID number shown is the same as that of plastic bag.
- Press the [YES] key if the ID number is correct. Press the [NO] key if incorrect, to return to the step 3) and try again.
- «ID registration in process» is displayed and registration starts.
- «ID registration done...» will be displayed when the registration process is done.
- To exit, select «END:NO», and press the [NO] key to return to {8. Keyless transmitter ID registration}. If there are additional keyless transmitters to be registered, select «Next registration:YES», and press the [YES] key to return to the step 3).NOTE:
- If the registration fails, «ID registration failed. Try again.» will be shown. Press the [YES] key to return to the {8. Transmitter ID registration}. And retry from the step 2).
- «END: NO» is shown on the Subaru Select Monitor when fourth keyless transmitter has been registered. Press the [NO] key to return to {8. Keyless transmitter ID registration}.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.