SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSREAR GATE OUTER HANDLEREMOVAL
2007 Subaru Outback Limited, 4D Sedan, Standard

Rear Gate Outer Handle: Removal

2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Removal
  1. Remove the rear gate trim. < Ref. to REMOVAL , Rear Gate Trim. >
  2. Remove the rear gate garnish. < Ref. to REMOVAL , Rear Gate Garnish. >
  3. Remove the two nuts, and take out the rear gate outer handle.
  4. Remove cable (1) of the rear gate handle.
    Fig 1: Locating Rear Gate Outer Handle Nuts
    G05022811Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.