Impact Sensitivity Adjustment

2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Impact Sensitivity Adjustment
  1. Connect the Subaru Select Monitor to the data link connector.
  2. Turn the ignition switch to ON.
  3. Select {Impact Sensor} from the main menu.
  4. Make a {Sensitivity Adjustment Mode}
    • Sensitivity can be adjusted in 11 levels (0 to 10).
    • Initial setting is 5.
    • Smaller number means more sensitive.
    • Larger number means less sensitive.
  5. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
    NOTE:
    • Set the sensor so as not to let the alarm on normal vibration (reclining to the door, hit the ball and etc.).
    • Set the sensor to operate the alarm with hitting the door or window glass, etc. continuously like a mayhem by robbery.
    • Ask the customer about parking situation for setting, because the alarm operate when the vibration not only the burglar but also the construction etc.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.