Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSIMPACT SENSORADJUSTMENTCHECK IMPACT SENSOR
2007 Subaru Outback Limited, 4D Sedan, Standard
Check Impact Sensor
2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Check Impact Sensor
- Remove the key from ignition switch.
- Close all the windows.
- Close all the doors, trunk lid and rear gate. Leave open the front hood.
- Press the LOCK button of the keyless transmitter from outside of vehicle.
- Check that the security indicator light blinks twice within 0.5 seconds in 2 second cycles after 30 seconds.
- Hit the windshield with your palm continuously and check the security alarm operates. Lift up the front hood approx. 12 cm (4.7 in) or more, and then drop it off to check the operation of security alarm.
- If NG, adjust the impact sensitivity.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.