Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMSIDE TURN SIGNAL LIGHT ASSEMBLYREMOVAL
2007 Subaru Outback Limited, 4D Sedan, Standard
Side Turn Signal Light Assembly: Removal
2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Removal
- Disconnect the ground cable from battery.
- Remove the scalp cap. <Ref. to REPLACEMENT , Scalp Cap .>
- Remove the mirror. <Ref. to REPLACEMENT , Outer Mirror .>
- Disconnect the harness connector, remove the 3 mounting screws and then remove the side turn signal light assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.