Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMHIGH-MOUNTED STOP LIGHTREMOVALSEDAN MODEL
2007 Subaru Outback Limited, 4D Sedan, Standard
Sedan Model
2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Sedan Model
- Disconnect the ground cable from battery.
- Push the high-mounted stop light towards the rear of the vehicle (1), raise the rear end (2) and remove the clips to remove the stop light
- Remove the harness from the clamp.
- Disengage two claws (A), pull out the high-mounted stop light from the cover and remove claw (B).
- Disengage the three claws and remove lens (A).
- Remove the bulb.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.