Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMFRONT FOG LIGHT ASSEMBLYREMOVALEXCEPT FOR OUTBACK MODEL

2007 Subaru Outback Limited, 4D Sedan, Standard

Except For Outback Model

2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Except For Outback Model

Disconnect the ground cable from the battery.
Remove the front fog light cover (A).

Fig 1: Identifying Front Fog Light Cover
Courtesy of SUBARU OF AMERICA, INC.
Disengage the two clips, and then turn over the lower mud guard.

Fig 2: Locating Lower Mud Guard Clips
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the harness connector.
Remove the mounting bolts, and pull and detach the fog light assembly.

Fig 3: Locating Fog Light Assembly Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.