Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007OUTBACK LIMITED, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEFUEL DELIVERYFUEL INJECTION SYSTEM (H4SO)INTAKE MANIFOLDASSEMBLY
2007 Subaru Outback Limited, 4D Sedan, Standard
Intake Manifold: Assembly
2007 Subaru Outback Limited, 4D Sedan, StandardSECTION Assembly
NOTE:
When assembling the nipple, apply liquid gasket.
Liquid gasket: THREE BOND 1105 (Part No. 004403010)
- Tighten the bolts which install fuel pipes on intake manifold.
Tightening torque: 6.4 N.m (0.65 kgf-m, 4.7 ft-lb)
- Connect the fuel injector pipe LH to the fuel pipe.NOTE: Connect the quick connector securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.