Judgment Value

2007 Subaru Legacy i, 4D Wagon, AutomaticSECTION Judgment Value
MALFUNCTION CRITERIA AND THRESHOLD VALUE REFERENCE

Malfunction Criteria Threshold Value
Estimated exhaust gas temperature < Value from Map 1


MALFUNCTION CRITERIA AND THRESHOLD VALUE REFERENCE

Malfunction Criteria Threshold Value
Estimated exhaust gas temperature ≥ Value from Map 1
  • Idle speed diagnosis

Judge as NG when all of the following conditions are established, and judge as OK when the following conditions are not met.

MALFUNCTION CRITERIA AND THRESHOLD VALUE REFERENCE

Malfunction Criteria Threshold Value
Continuous time of (Target engine speed - Actual engine speed > 100 rpm) ≥ 6000 ms

Time Needed for Diagnosis:  6 seconds

Malfunction Indicator Light Illumination:  Illuminates when malfunction occurs in 2 continuous driving cycles.



MALFUNCTION CRITERIA AND THRESHOLD VALUE REFERENCE

Malfunction Criteria Threshold Value
Average of intake air amount < Value from Map 1
Average of total retard angle amount > Value from Map 2


MALFUNCTION CRITERIA AND THRESHOLD VALUE REFERENCE

Malfunction Criteria Threshold Value
Average of intake air amount > Value from Map 1
  • Idle speed diagnosis

After the establishment of diagnostic enable conditions, judge as NG if the continuous time during which the following conditions are established exceeds the predetermined time, and judge as OK if it does not.



MALFUNCTION CRITERIA AND THRESHOLD VALUE REFERENCE

Malfunction Criteria Threshold Value
Target engine speed - Measured engine speed > Value from Map 3
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.