Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2007LEGACY I, 4D WAGON, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDIAGNOSTIC TROUBLE CODE (DTC) DETECTING CRITERIA (H4SO)DIAGNOSTIC TROUBLE CODE (DTC) DETECTING CRITERIADTC P0335 CRANKSHAFT POSITION SENSOR "A" CIRCUITOUTLINE OF DIAGNOSIS
2007 Subaru Legacy i, 4D Wagon, Automatic
Outline Of Diagnosis
2007 Subaru Legacy i, 4D Wagon, AutomaticSECTION Outline Of Diagnosis
Detect the open or short circuit of the crankshaft position sensor.
Judge as NG when the crank signal is not input even though the starter was rotated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.