Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Use General Scan Tool
- Prepare a scan tool (general scan tool) required by SAE J1978.
- Open the cover and connect the general scan tool to the data link connector located in the lower portion of instrument panel (on the driver's side).
- Using the general scan tool, call up DTC and freeze frame data.
General scan tool functions consist of:
- MODE $01: Current powertrain diagnostic data
- MODE $02: Powertrain freeze frame data
- MODE $03: Emission-related powertrain DTC
- MODE $04: Clear/Reset emission-related diagnostic information
- MODE $06: Request on-board monitoring test results for intermittently monitored systems
- MODE $07: Request on-board monitoring test results for continuously monitored systems
- MODE $09: Request vehicle information
Read out the data according to repair procedures. (For detailed operation procedure, refer to the general scan tool instruction service information.)
NOTE: For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".<Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .>
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.